A concept for an ergonomic shoehorn handle. I compared handle types and finger actions in a sketch matrix, then modeled a D-shaped loop handle in CAD. The drawing calls for a wooden body with a ribbed rubber insert under the top bar and subtle thumb grooves on both sides, so the grip works for left- and right-handed users. The project is documented as sketches, renders and a drawing.
Shoehorn Handle
A D-shaped shoehorn handle with a ribbed rubber grip and thumb grooves for either hand.

Overview
Challenge
A grip has to work across very different hand sizes. My drawing notes set the target: design for the 95th percentile, leave a 140 x 50 mm opening so big hands fit, and skip finger grooves so the handle does not favor one hand size.
“No finger grooves to fit everyone.”


Process
I started with a matrix crossing handle types with finger actions and circled two directions: loop handles and pistol grips. I developed the loop handle in CAD, rendered it, composited a hand over the render to show the grip, and made a drawing annotated with dimensions and grip details.
Sketch matrix
Pencil sketches crossed handle types with finger actions; loop and pistol grips were circled.
CAD model
A D-shaped loop handle with a ribbed rubber insert, thumb grooves and a stub for the shaft.
Drawing
A dimensioned drawing, annotated with the grip details and the 95th-percentile target.

Outcome
The result is a CAD model and a drawing titled Final Handle, dated February 12, 2026. The handle is 170 mm wide with a 140 x 50 mm opening. Ribs on the rubber insert add friction so less grip strength is needed, and the top bar is not fully round for a better hold. Renders with hands show the thumb resting in the grooves from either side.
170
mm overall width
140
mm wide grip opening, 50 mm tall
95th
percentile the design targets, per drawing notes
Automata